The formula behind it
σ = F ÷ A- F
- axial force in newtons
- A
- cross-sectional area in mm² (or derived from diameter / width × height)
Normal stress is the internal force intensity: how hard the material's cross-section is being pulled (tension) or squeezed (compression) per unit area. Steel yields near 250 MPa, aluminum alloys span 200–500 MPa, so stress answers are compared against material allowables with a safety factor — never used alone. The calculator accepts a direct area, a circular section, or a rectangle.
How to use this calculator
- 1
Enter the axial force in newtons.
- 2
Give the cross-section: direct mm², a circle's diameter, or a rectangle's width × height.
- 3
Press Calculate to see stress in MPa, Pa and psi.
Worked examples
Tie rod
10 kN on a 100 mm² section → σ = 10⁴ ÷ 10⁻⁴ = 100 MPa.
M10 bolt
5 kN on ~58 mm² (M10 shank) → ≈ 86 MPa — far below bolt grades' 800+.